Sapphire Plug-ins for After Effects: Dissolve

S_Dissolve A basic cross fade between two input clips. In the Sapphire Transitions effects submenu. Inputs: Foreground: The current layer. Starts the transition with this clip. Background: Defaults to None. Ends the transition with this clip. If this input is not provided, a fully transparent background is used, showing whatever is behind it. Note that the background can not be warped during the transition unless this input is provided.

Parameters:

Load Preset: Push-button .
Brings up the Preset Browser to browse all available presets for this effect.

Save Preset: Push-button .
Brings up the Preset Save dialog to save a preset for this effect.

Transition Dir: Popup menu,  Default: Dissolve Off to Bg .
Selects the direction of the transition.

Dissolve Off to Bg: transitions from the current layer to the Background.

Dissolve On from Bg: transitions from the Background to the current layer.

Auto Trans: Popup YES-NO,  Default: No .
If enabled, a transition is performed automatically between the first and last frames of the layer. If this is off, the transition is performed manually by animating the Dissolve Percent parameter.

Dissolve Percent: Default: 0, Range: 0 to 1.
Auto Trans must be disabled for this parameter to be used. It determines the transition ratio between the Foreground and Background inputs, and would normally be animated from 0 to 100 to perform a complete transition. The curve controlling this parameter can be adjusted for more detailed control over the timing of the dissolve. The Slow In and Slow Out parameters, if positive, also adjust the transition ratio internally for a smoother start and/or end to the transition.

Dissolve Speed: Default: 1, Range: 1 or greater.
The speed of the dissolve between the From and To clips. When set to 1, the dissolve takes place over the entire duration of the effect. When set higher, the dissolve is shorter, although the glow ramp-up and ramp-down still takes the entire duration. Setting this to 10 can make the transition snappier and more like a flash-frame cut.

Slow In: Default: 0.2, Range: 0 to 1.
If positive, causes the transition to start more gradually.

Slow Out: Default: 0.2, Range: 0 to 1.
If positive, causes the transition to end more gradually.

See Also:

DissolveBlur DissolveBubble DissolveDiffuse DissolveFilm DissolveGlow DissolveLuma DissolvePuddle DissolveSpeckle DissolveStatic DissolveVortex DissolveWaves

Sapphire Plug-ins Introduction